Morning all.. Im wanting to change my drivers side drive shaft , as I think I got a bad inner cv.. I've done loads of digging , and seems that inner cvs don't fail ... Either way I have another complete shaft to swap ..
So here's a few questions .. Although it doesn't look too difficult .. Just after a few pointers .. Has anyone used a cheapie hub press to push the shaft out of the hub of siezed ?? If so what press did you use . And would you remove the ball joint via the 13mms or the single nut ??
Any idea of how long it should take to swap if all goes well!?
Regards Tony
So here's a few questions .. Although it doesn't look too difficult .. Just after a few pointers .. Has anyone used a cheapie hub press to push the shaft out of the hub of siezed ?? If so what press did you use . And would you remove the ball joint via the 13mms or the single nut ??
Any idea of how long it should take to swap if all goes well!?
Regards Tony